| Commit message (Collapse) | Author | Age | |
|---|---|---|---|
| * | mediatek: convert to new LED color/function format where possible | Christian Marangi | 2024-02-07 |
| | | | | | | | | | Initial conversion to new LED color/function format and drop label format where possible. The same label is composed at runtime. Signed-off-by: Christian Marangi <ansuelsmth@gmail.com> | ||
| * | mediatek: fiilogic: device tree `switch@1f` fix | Rani Hod | 2023-11-22 |
| | | | | | | | | | | | | | | | | Quite a few `fiilogic` devices use the `mt7531` switch. Some of them have a DT node that looks like: ``` switch: switch@0 { compatible = "mediatek,mt7531"; reg = <31>; ... }; ``` This commit changes the DT node name to `switch@1f`. Signed-off-by: Rani Hod <rani.hod@gmail.com> | ||
| * | mediatek: fix the name of buswidth to bus-width | Chen Minqiang | 2023-09-05 |
| | | | | | | | | | | | | Fix the issue of dts buswidth cannot be applied properly with spi driver. Fix the name of buswidth to bus-width in dts in order to fit the format in linux spi kernel[1] so that spi-tx-bus-width & spi-rx-bus-width can be parsed properly. [1] Documentation/devicetree/bindings/spi/spi-controller.yaml Signed-off-by: Chen Minqiang <ptpt52@gmail.com> | ||
| * | mediatek: filogic: add Qihoo 360T7 support | Chukun Pan | 2023-05-27 |
| Hardware specification: SoC: MediaTek MT7981B 2x A53 Flash: ESMT F50L1G41LB 128MB RAM: MT5CC128M16JR-EK 256MB Ethernet: 4x 10/100/1000 Mbps Switch: MediaTek MT7531AE WiFi: MediaTek MT7976C Button: Reset, WPS Power: DC 12V 1A Flash instructions: 1. Attach UART, boot the stock firmware until the message about failsafe mode appears. 2. Enter failsafe mode by pressing "f" and "Enter" 3. Type "mount_root", then run "fw_setenv bootmenu_delay 3" 4. Back up all mtd partitions before flashing. 5. Reboot, U-Boot now presents a menu. 6. Connect to your PC via the Gigabit port of the router, set a static ip on the ethernet interface of your PC. (ip 192.168.1.254, gateway 192.168.1.1) 7. Select "Upgrade ATF BL2", then use this file: openwrt-mediatek-filogic-qihoo_360t7-preloader.bin 8. Select "Upgrade ATF FIP", then use this file: openwrt-mediatek-filogic-qihoo_360t7-bl31-uboot.fip 9. Download the initramfs image, and type "reset", waiting for tftp recovery to complete. a. After openwrt boots up, perform sysupgrade. Note: 1. Since NMBM is disabled, we must back up all partitions. 2. Flash instructions is based on commit 28df7f7. Signed-off-by: Chukun Pan <amadeus@jmu.edu.cn> | |||