aboutsummaryrefslogtreecommitdiff
path: root/target/linux/ipq40xx/patches-5.15
Commit message (Collapse)AuthorAge
* ipq40xx: add MikroTik wAP ac (RBwAPG-5HacD2HnD) supportMark Mentovai2022-07-18
| | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | The MikroTik wAP ac (RBwAPG-5HacD2HnD) is a dual-band dual-radio 802.11ac wireless access point with integrated antenna and two Ethernet ports in a weatherproof enclosure. See https://mikrotik.com/product/wap_ac for more information. Important: this is the new ipq40xx-based wAP ac, not the older ath79-based wAP ac (RBwAPG-5HacT2HnD), already supported in OpenWrt. Specifications: - SoC: Qualcomm Atheros IPQ4018 - CPU: 4x ARM Cortex A7 - RAM: 128MB - Storage: 16MB NOR flash - Wireless - 2.4GHz: Built-in IPQ4018 (SoC) 802.11b/g/n 2x2:2, 2.5 dBi antennae - 5GHz: Built-in IPQ4018 (SoC) 802.11a/n/ac 2x2:2, 2.5 dBi antennae - Ethernet: Built-in IPQ4018 (SoC, QCA8075), 2x 1000/100/10Mb/s ports, one with 802.3af/at PoE in Installation: Boot the initramfs image via TFTP, then flash the sysupgrade image using sysupgrade. Details at https://openwrt.org/toh/mikrotik/common. Notes: This preserves the MAC addresses of the physical Ethernet ports: - eth0 corresponds to the physical port labeled ETH1 and has the base MAC address. This port can be used to power the device. - eth1 corresponds to the physical port labeled ETH2 and has a MAC address one greater than the base. MAC addresses are set from /lib/preinit/05_set_iface_mac_ipq40xx.sh rather than /etc/board.d/02_network so that they are in effect for preinit. This should likely be done for other MikroTik devices and possibly other non-MikroTik devices as well. As this device has 2 physical ports, they are each connected to their respective PHYs, allowing the link status to be visible to software. Since they are not marked on the case with any role (such as LAN or WAN), both are bridged to the lan network by default, although this can easily be changed if needed. Signed-off-by: Mark Mentovai <mark@mentovai.com>
* ipq40xx: add support for Meraki MR74Matthew Hagan2022-06-19
| | | | | | | | | | | | The Meraki MR74 is part of the "Insect" series. This device is essentially an outdoor variant of the MR33 with identical hardware, but requiring a config@3 DTS option to be set to allow booting with the stock u-boot. The install procedure is replicated from the MR33, with the exception being that the MR74 sysupgrade image must be used. Signed-off-by: Matthew Hagan <mnhagan88@gmail.com>
* kernel: move Toshiba-TC58NVG0S3H patch to ipq40xx reduxChristian Lamparter2022-06-19
| | | | | | | | | | | | | | | | | | Linux' upstream MTD-Maintainer Miquèl Raynal noted: |Reverting seems the safest option here, not knowing how many devices |have these damaged/counterfeit chips. If it is just a couple and only on |Fritzboxes, as suggested in the Github issue this patch could be |carried through OpenWrt and that would seem more future proof IMHO. This patch follows up with the first patch. It actually moves the patches out of target/linux/generic/pending into the ipq40xx's patch heap and adds a little note what happend. For more information, discussions or reports about bad TC58NVG0S3Hs, please visit the OpenWrt's Github Issue #9962: <https://github.com/openwrt/openwrt/issues/9962> Signed-off-by: Christian Lamparter <chunkeey@gmail.com>
* kernel: bump 5.15 to 5.15.45Rui Salvaterra2022-06-06
| | | | | | Patches automatically rebased. Signed-off-by: Rui Salvaterra <rsalvaterra@gmail.com>
* ipq40xx: add support for Linksys WHW01 v1Peter Adkins2022-06-05
| | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | This patch adds support for Linksys WHW01 v1 ("Velop") [FCC ID Q87-03331]. Specification ------------- SOC: Qualcomm IPQ4018 WiFi 1: Qualcomm QCA4019 IEEE 802.11b/g/n WiFi 2: Qualcomm QCA4019 IEEE 802.11a/n/ac Bluetooth: Qualcomm CSR8811 (A12U) Ethernet: Qualcomm QCA8072 (2-port) SPI Flash 1: Mactronix MX25L1605D (2MB) SPI Flash 2: Winbond W25M02GV (256MB) DRAM: Nanya NT5CC128M16IP-DI (256MB) LED Controller: NXP PCA963x (I2C) Buttons: Single reset button (GPIO). Notes ----- There does not appear to be a way to trigger TFTP recovery without entering U-Boot. The device must be opened to access the serial console in order to first flash OpenWrt onto a device from factory. The device has automatic recovery backed by a second set of partitions on the larger of the two SPI flash ICs. Both the primary and secondary must be flashed to prevent accidental rollback to "factory" after 3 failed boot attempts. Serial console -------------- A serial console is available on the following pins of the populated J2 connector on the device mainboard (115200 8n1). (<-- Top of PCB / Device) J2 [o o o o o o] | | | | | `-- GND | `---- TX `--------- RX Installation instructions ------------------------- 1. Setup TFTP server with server IP set to 192.168.1.236. 2. Copy compiled `...squashfs-factory.bin` to `nodes-jr.img` in tftp root. 3. Connect to console using pinout detailed in the serial console section. 4. Power on device and press enter when prompted to drop into U-Boot. 5. Flash first partition device via `run flashimg`. 6. Once complete, reset device and allow to power up completely. 7. Once comfortable with device upgrade reboot and drop back into U-Boot. 8. Flash the second partition (recovery) via `run flashimg2`. Revert to "factory" ------------------- 1. Download latest firmware update from vendor support site. 2. Copy extracted `.img` file to `nodes-jr.img` in tftp root. 3. Connect to console using pinout detailed in the serial console section. 4. Power on device and press enter when prompted to drop into U-Boot. 5. Flash first partition device via `run flashimg`. 6. Once complete, reset device and allow to power up completely. 7. Once comfortable with device upgrade reboot and drop back into U-Boot. 8. Flash the second partition (recovery) via `run flashimg2`. Link: https://github.com/openwrt/openwrt/pull/3682 Signed-off-by: Peter Adkins <peter@sunkenlab.com> (calibration from nvmem, updated to 5.10+5.15) Signed-off-by: Christian Lamparter <chunkeey@gmail.com>
* kernel: bump 5.15 to 5.15.39John Audia2022-05-16
| | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | Removed upstreamed: backport-5.15/850-v5.17-0001-PCI-pci-bridge-emul-Add-description-for-class_revisi.patch backport-5.15/850-v5.17-0002-PCI-pci-bridge-emul-Add-definitions-for-missing-capa.patch backport-5.15/850-v5.17-0003-PCI-aardvark-Add-support-for-DEVCAP2-DEVCTL2-LNKCAP2.patch backport-5.15/850-v5.17-0004-PCI-aardvark-Clear-all-MSIs-at-setup.patch backport-5.15/850-v5.17-0005-PCI-aardvark-Comment-actions-in-driver-remove-method.patch backport-5.15/850-v5.17-0006-PCI-aardvark-Disable-bus-mastering-when-unbinding-dr.patch backport-5.15/850-v5.17-0007-PCI-aardvark-Mask-all-interrupts-when-unbinding-driv.patch backport-5.15/850-v5.17-0008-PCI-aardvark-Fix-memory-leak-in-driver-unbind.patch backport-5.15/850-v5.17-0009-PCI-aardvark-Assert-PERST-when-unbinding-driver.patch backport-5.15/850-v5.17-0010-PCI-aardvark-Disable-link-training-when-unbinding-dr.patch backport-5.15/850-v5.17-0011-PCI-aardvark-Disable-common-PHY-when-unbinding-drive.patch pending-5.15/850-0001-PCI-aardvark-Replace-custom-PCIE_CORE_INT_-macros-wi.patch pending-5.15/850-0004-PCI-aardvark-Rewrite-IRQ-code-to-chained-IRQ-handler.patch pending-5.15/850-0005-PCI-aardvark-Check-return-value-of-generic_handle_do.patch pending-5.15/850-0006-PCI-aardvark-Make-MSI-irq_chip-structures-static-dri.patch pending-5.15/850-0007-PCI-aardvark-Make-msi_domain_info-structure-a-static.patch pending-5.15/850-0008-PCI-aardvark-Use-dev_fwnode-instead-of-of_node_to_fw.patch pending-5.15/850-0009-PCI-aardvark-Refactor-unmasking-summary-MSI-interrup.patch pending-5.15/850-0010-PCI-aardvark-Add-support-for-masking-MSI-interrupts.patch pending-5.15/850-0011-PCI-aardvark-Fix-setting-MSI-address.patc pending-5.15/850-0012-PCI-aardvark-Enable-MSI-X-support.patch pending-5.15/850-0013-PCI-aardvark-Add-support-for-ERR-interrupt-on-emulat.patch pending-5.15/850-0015-PCI-aardvark-Optimize-writing-PCI_EXP_RTCTL_PMEIE-an.patch pending-5.15/850-0016-PCI-aardvark-Add-support-for-PME-interrupts.patch pending-5.15/850-0017-PCI-aardvark-Fix-support-for-PME-requester-on-emulat.patch pending-5.15/850-0018-PCI-aardvark-Use-separate-INTA-interrupt-for-emulate.patch pending-5.15/850-0019-PCI-aardvark-Remove-irq_mask_ack-callback-for-INTx-i.patch pending-5.15/850-0020-PCI-aardvark-Don-t-mask-irq-when-mapping.patch pending-5.15/850-0021-PCI-aardvark-Drop-__maybe_unused-from-advk_pcie_disa.patch pending-5.15/850-0022-PCI-aardvark-Update-comment-about-link-going-down-af.patch All patches automatically rebased. Build system: x86_64 Build-tested: bcm2711/RPi4B, mt7622/RT3200 Run-tested: bcm2711/RPi4B, mt7622/RT3200 Signed-off-by: John Audia <therealgraysky@proton.me>
* kernel: bump 5.15 to 5.15.36Rui Salvaterra2022-05-09
| | | | | | Patches automatically rebased. Signed-off-by: Rui Salvaterra <rsalvaterra@gmail.com>
* ipq40xx: 5.15: drop upstreamed sleep clock patchRobert Marko2022-05-01
| | | | | | | Patch that corrects sleep clock frequency has already been backported to 5.15 stable so remove the duplicate patch. Signed-off-by: Robert Marko <robert.marko@sartura.hr>
* ipq40xx: 5.15: refresh kernel patchesAnsuel Smith2022-05-01
| | | | | | | Refresh kernel patches. Signed-off-by: Ansuel Smith <ansuelsmth@gmail.com> Reviewed-by: Robert Marko <robert.marko@sartura.hr>
* ipq40xx: 5:15: refresh patchesAnsuel Smith2022-05-01
| | | | | | | - Drop upstream patch - Refresh dts patch Signed-off-by: Ansuel Smith <ansuelsmth@gmail.com>
* ipq40xx: 5:15: copy config and patch from 5.10Ansuel Smith2022-05-01
Copy config and patch from 5.10 to 5.15 Signed-off-by: Ansuel Smith <ansuelsmth@gmail.com>
Powered by cgit, Themed by Ted Yin.